#Re webbing aluminum lawn chairs how to#
#Re webbing aluminum lawn chairs professional#

Use a pipe clamp to spread the rails slightly if need be, bend the bar a bit to make it fit, then hit it with a rubber mallet to restore its shape. Tighten the loose bolts on the opposite rail to make the sling taut. Slide the detached rail over the sling’s other nylon rod.Hold the sling with its hem side to the back and slide its nylon rod into the track of the rail that’s still attached to the chair frame. Loosen but don’t remove the bolts that attach the rails to the chair frame, then pop out the spreader bar. Slide the two halves of the sling out of their tracks in the chair’s rails.(A damaged sling cannot be saved.) Remove the end cap on each side rail. Slash the old sling down the middle with a utility knife.

To find the length, lay a cloth tape measure along the top face of one rail so it follows the rail’s curvature. Find the width by measuring from the center of one rail to the center of the opposite rail at the bolt locations (typically found at the top and bottom of the sling).

#Re webbing aluminum lawn chairs how to#

How to Replace the Mesh Sling on Patio Chairsīefore you being you’ll need to do some measurements.

That’s still only one-third to half the cost of buying new. The full-body treatment - blasting, repainting, welding, repairing straps, slings, or cushions, and replacing fasteners - runs about $120 for a typical chair. “The pieces come out looking brand-new,” says owner Steven Gentino. will sandblast and repaint furniture with a tough, powder-coated finish that will last 15 years or more. Factory-authorized refinishers like The Chair Care Co.

#Re webbing aluminum lawn chairs professional#

When a painted frame is covered with scratches or caked with rust, it’s probably time for a professional overhaul. (A coat of rust converter such as Rust Reformer stabilizes rust without sanding, but a rough, crusty look will remain.)

Next, brush or spray on a metal primer, then apply an exterior enamel topcoat. Use a tiny touch-up brush on nicks, a spray can on bigger scratches.įor wrought iron on tubular steel, use a wire brush and sandpaper to sand any rust spots or chipped paint down to bare metal. There’s no need to prime - just apply an exterior-grade acrylic enamel paint. The method to use depends on the type of metal to be painted.įor aluminum, rough up the surface slightly with 100-grit sandpaper, then smooth with 220-grit paper. The time to touch up nicks and scratches on the frame is after the old straps or slings have been removed and before the new ones go on. Here’s how Gentino revived two types of painted aluminum chairs: one with a vinyl-strap back and seat and the other with a one-piece mesh sling. “All you need to do is a little measuring,” Gentino says. “It takes a little muscle and a couple of hours tops.” Gentino’s company is one of many nationwide that can supply the necessary materials, fasteners, and even the touch-up paint look for “outdoor furniture care” on the Web, or contact the chair manufacturer for a list of authorized repair services. “This is something homeowners can definitely do,” says Steven Gentino, owner of The Chair Care Co., an outdoor-furniture refinisher in New Haven, Connecticut. For a fraction of the cost of replacement, you can tackle basic repairs yourself. Mesh slings rip, and fasteners pop out.īut that doesn’t mean you have to toss the old set and buy new. Frames accumulate unsightly nicks, scratches, and rust. Left outdoors in rain and shine, metal deck and patio furniture take a beating.